Identification of nine acetylenic fatty acids, 9-hydroxystearic acid and 9,10-epoxystearic acid in the seed oil ofJodina rhombifolia hook et arn. (Santalaceae)

In addition to some usual fatty acids, the seed oil ofJodina rhombifolia (Santalaceae) contains nine acetylenic fatty acids [9-octadecynoic acid (stearolic acid) (1.1%),trans-10-heptadecen-8-ynoic acid (pyrulic acid) (20.1%), 7-hydroxy-trans-10-heptadecen-8-ynoic acid (2.3%),trans-10,16-heptadecadien-8-ynoic acid (0.7%), 7-hydroxy-trans-10,16-heptadecadien-8-ynoic acid (0.1%),trans-11-octadecen-9-ynoic acid (ximenynic acid) (20.3%), 8-hydroxy-trans-11-octadecen-9-ynoic acid (12.2%),trans-11,17-octadecadien-9-ynoic acid (1.5%), 8-hydroxy-trans-11,17-octadecadien-9-ynoic acid (1.3%), 9-hydroxystearic acid (<0.1%) and 9,10-epoxystearic acid (0.7%)]. The fatty acids have been analyzed by gas chromatography/mass spectrometry of their methyl ester and 4,4-dimethyloxazoline derivatives. The hydroxy fatty acid methyl esters have been examined also as trimethyl-silyl ethers. Furthermore, the fatty acid methyl esters (FAME) have been fractionated according to their polarity (FAME-A: nonhydroxy; FAME-B: hydroxy fatty acids) and to their degree of unsaturation (FAME-A1/A2; FAME-B1/B2) by preparative thin-layer chromatography and argentation chromatography, respectively. All of these fractions have been analyzed by ultraviolet and infrared spectroscopy, and the fractions FAME-A and FAME-B have been analyzed further by nuclear magnetic resonance (¹H,¹³C, 2D H/C, attached proton test) spectroscopy and gas chromatography/mass spectrometry. This work is dedicated to the 65th birthday of Prof. Dr. K. Pfeilsticker, Institut of Food Science, University Bonn (Germany).     

Eco-friendly electronics,based on nanocomposites of biopolyester reinforced with carbon nanotubes: a review

ABSTRACT

Fabrication of electronic materials from nanocomposite of biopolyesters reinforced with carbon nanotubes can be regarded as the effective alternative for conventional nanocomposites consisting of non-biodegradable polymers. Commercial availability of biopolyester-based nanocomposites is limited because of their high cost compared to other polymers, but the factor of their compostable nature is worthless for environmental protection. Such nanocomposites have potential applications in biodegradable sensors, EMI materials, etc. In this review, the current progress of biopolyester/CNTs nanocomposites in the field of biodegradable electronics is reviewed and also the impact of CNTs dispersion on electrical, thermal and mechanical properties of eco composites is stipulated.     

Assessment of a redox alkaline/iron-chelate absorption process for the removal of dilute hydrogen sulfide in air emissions

The oxidative absorption of hydrogen sulfide (H₂S) into a solution of ferric chelate of trans-1,2- diaminocyclohexanetetraacetate (CDTA) was studied in a counter-current laboratory column randomly packed with 15 mm plastic Ralu rings. The present investigation takes concern about the Kraft pulping situation where dilute H₂S concentrations are omnipresent in large-volume gas effluents. A fractional two-level factorial approach was instigated to determine the significance of six operating variables, namely the solution's alkalinity (pH; 8.5-10.5), the liquid mass flow rate (L;1.73-), the solution's ionic strength (I_C;0.01-), the gas mass flow rate (G;0.19-), the inlet H₂S concentration (C_H2S,0;70-430 ppm) and the initial ferric CDTA concentration (C_Fe,0;100 -). Initially, a Plackett-Burman design matrix of seven duplicated experiments revealed that pH is the leading factor controlling the H₂S conversion rate while the ionic strength and ferric CDTA concentration effects remained negligible within the factorial domain. Surface response analysis based on 11 duplicated factorial experiments plus 10 central composite trials revealed that the H₂S conversion significantly increases with liquid flow rate but decreases with growing H₂S load up. Further examination about the influence of ferric CDTA on H₂S absorption rate was set up over a broader concentration range (C_Fe,0;0- at pH of 9.5 and 10.5. It showed good potential at as H₂S conversion increased by a significant 25% for both pH values in comparison to pure alkaline solutions containing no ferric CDTA.     

The ring transformations of 1,2,3,4-diepoxybutane (2,2′-bioxirane) catalysed by various aluminosilicates

The transformations of a molecule containing two adjacent epoxide rings, 2,2-bioxirane that is, were studied over various acidic aluminosilicates (HZSM-5, HY-FAU, AlMCM-41), for the first time, In the 373–473 K temperature range, in a pulse reactor, a ring-opening–ring-enlargment reaction producing furan only occured over the zeolites and it was the predominant reaction on AlMCM-41 as well. The driving force of this transformation route is water formation via elimination from 2,2-bioxirane. Suprising is the lack of the mono- or dialdehyde, the would-be products of the cleavage of the sterically more hindered C–O bonds – an acid-catalysed reaction typical for alkyl-substituted oxiranes.     

Investigation on the early and late stage phase-separation dynamics of poly(methyl methacrylate)/poly(α-methyl styrene-co-acrylonitrile) blends through rheological and scattering functions

The phase-separation behavior of poly(methyl methacrylate)/poly(α-methyl styrene-co-acrylonitrile) (PMMA/α-MSAN) blends with two different compositions was studied by time-resolved small angle light scattering (SALS) in the spinodal decomposition (SD) regime from 160 to 210 °C. The rheological function (WLF-like equation) was introduced into the processing of light scattering data. It was found that the WLF-like equation was applicable to describe the temperature dependence of apparent diffusion coefficient D_app and the relaxation time τ of normalized scattering intensity (I(t)−I(0))/(I_m−I(0)) at the early stage of SD, as well as the relaxation time τ of maximum scattering intensity I_m and characteristic scattering vector q_m with I_m at the late stage of SD for PMMA/α-MSAN blends with two different compositions. This is in consistence with the phase-separation behavior of PMMA/SAN reported in our previous paper.     

Reducing the Sintering Temperature for MgO–Al2O3Mixtures by Addition of Cryolite (Na3AlF6)

The preparation of near stoichiometric spinel and alumina-rich spinel composites from Al₂O₃and MgO powders with the addition of Na₃AlF₆up to 4 wt% in the temperature range 700°–1600°C was studied; 98 wt% spinel containing 72 wt% Al₂O₃can be produced from the mixture of 72 wt% (50 at.%) Al₂O₃+ 28 wt% (50 at.%) MgO powders with the addition of 1 wt% Na₃AlF₆fired at 1300°C for 1 h. Spinels containing 81–85 wt% Al₂O₃can be produced from either the mixture of 90 wt% (78 at.%) Al₂O₃+ 10 wt% (22 at.%) MgO or the mixture of 95 wt% (88 at.%) Al₂O₃+ 5 wt% (12 at.%) MgO powders with the addition of 4 wt% Na₃AlF₆in the temperature range 1300°–1600°C by using a torch-flame firing for 3 min, followed by quenching in water, while the same system under slow cooling in a furnace results in spinel containing 74–76 wt% Al₂O₃. Microscopic studies indicate that the alumina-rich spinel composites consist of a continuous majority spinel phase and an isolated minority corundum phase, regardless of slow cooling in a furnace or quenching in water.     

Flavonoids released by carrot (Daucus carota) seedlings stimulate hyphal development of vesicular-arbuscular mycorrhizal fungi in the presence of optimal CO2 enrichment

Carbon dioxide has been previously identified as a critical volatile factor that stimulates hyphal growth ofGigaspora margarita, a vesiculararbuscular mycorrhizal fungus, and we determined the optimal concentration at 2.0%. The beneficial effect of CO₂ on fungal development is also visible in the presence of stimulatory (quercetin, myricetin) or inhibitory (naringenin) flavonoids. Sterile root exudates from carrot seedlings stimulate the hyphal development ofG. margarita in the presence of optimal CO₂ enrichment. Three flavonols (quercetin, kaempferol, rutin or quercetin 3-rutinoside) and two flavones (apigenin, luteolin) were identified in carrot root exudates by means of HPLC retention time. Flavonols like quercetin and kaempferol are known to have stimulatory effects on hyphal growth ofG. margarita.     

Modification of glassy carbon electrode with multi-walled carbon nanotubes and iron(III)-porphyrin film: Application to chlorate, bromate and iodate detection

In this study, multi-wall carbon nanotubes (MWCTs) is evaluated as a transducer, stabilizer and immobilization matrix for the construction of amperometric sensor based on iron-porphyrin. 5,10,15,20-Tetraphenyl-21H,23H-porphine iron(III) chloride (Fe(III)P) adsorbed on MWCNTs immobilized on the surface of glassy carbon electrode. Cyclic voltammograms of the Fe(III)P-incorporated-MWCNTs indicate a pair of well-defined and nearly reversible redox couple with surface confined characteristics at wide pH range (2-12). The surface coverage (Γ) and charge transfer rate constant (k_s) of Fe(III)P immobilized on MWCNTs were 7.68 × 10⁻⁹ mol cm⁻² and 1.8 s⁻¹, respectively, indicating high loading ability of MWCNTs for Fe(III)P and great facilitation of the electron transfer between Fe(III)P and carbon nanotubes immobilized on the electrode surface. Modified electrodes exhibit excellent electrocatalytic activity toward reduction of ClO₃⁻, IO₃⁻ and BrO₃⁻ in acidic solutions. The catalytic rate constants for catalytic reduction of bromate, chlorate and iodate were 6.8 × 10³, 7.4 × 10³ and 4.8 × 10² M⁻¹ s⁻¹, respectively. The hydrodynamic amperometry of rotating-modified electrode at constant potential versus reference electrode was used for detection of bromate, chlorate and iodate. The detection limit, linear calibration range and sensitivity for chlorate, bromate and iodate detections were 0.5 μM, 2 μM to 1 mM, 8.4 nA/μM, 0.6 μM, 2 μM to 0.15 mM, 11 nA/μM, and 2.5 μM, 10 μM to 4 mM and 1.5 nA/μM, respectively. Excellent electrochemical reversibility of the redox couple, good reproducibility, high stability, low detection limit, long life time, fast amperometric response time, wide linear concentration range, technical simplicity and possibility of rapid preparation are great advantages of this sensor. The obtained results show promising practical application of the Fe(III)P-MWCNTs-modified electrode as an amperometric sensor for chlorate, iodate and bromate detections.     

Selected physical characteristics of polystyrene/high density polyethylene composites prepared from virgin and recycled materials

Mixtures of polystyrene and high density polyethylene were injection molded from recycled and virgin polymers to generate cocontinuous structures. The mechanical properties of these blends were evaluated to assess their conformance to rule of mixtures behavior in general and to identify areas of synergy or incompatibility in specific. Flexural and tensile data for recycled blends showed that generally the properties are not additive, except in a cocontinuous region of composition near 35/65 PS/HDPE that has been identified previously for recycled materials. Analysis of crystallinity in the HDPE phase of these blends by differential scanning calorimetry indicates a marked reduction in the level of HDPE crystallinity at the 35/65 PS/HDPE composition. Similar blends of virgin PS/HDPE polymer do not show the differing regions of incompatibility and synergy illustrated by the recycled materials, but rather show approximate conformance to the rule of mixtures. Furthermore, the virgin blends show virtually no crystallinity suppression and a more pronounced T_g shift in the polystyrene compared to recycled materials. Detailed characterization of the recycled materials in terms of polymer and particulate impurities should improve understanding of these differences and perhaps provide direction for obtaining enhanced synergistic behavior in virgin polymer blends. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci, 2006